Motor encoders and interrupts
Closed this issue · 1 comments
EncomLab commented
Hi Stefan - sorry for being away from this project for far too long! I have a question regarding the use of HC-020K optical encoders for motor control - namely the best way to use interrupts and/or the best commands to allow for the counting of pulses from them. I have attempted using the EVENT command but it appears I am getting a pulse length and not a count of pulses. Best regards and I look forward as always to your feedback! - Brian
slviajero commented
Hi Brian,
the EVENT command is tricky and not really well tested. What exactly are you trying to do with it.
Do you have some code you tried?
In general, EVENT is used to react to one event by jumping to a subroutine. There one has to count the
number of interrupts. Is this what you are trying to do?
Best Regards,
Stefan
… On 18. Mar 2024, at 01:41, Encom Lab ***@***.***> wrote:
Hi Stefan - sorry for being away from this project for far too long! I have a question regarding the use of HC-020K optical encoders for motor control - namely the best way to use interrupts and/or the best commands to allow for the counting of pulses from them. I have attempted using the EVENT command but it appears I am getting a pulse length and not a count of pulses. Best regards and I look forward as always to your feedback! - Brian
—
Reply to this email directly, view it on GitHub <#63>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ACSY56DUGN5WQLFOJ7UVZHTYYYZ3RAVCNFSM6AAAAABE2UYYV6VHI2DSMVQWIX3LMV43ASLTON2WKOZSGE4TCMBQGQ2DAMQ>.
You are receiving this because you are subscribed to this thread.