StealthOrbiter

This mod aims to mount the Orbiter V2.0 extruder to the Voron Stealthburner & crowncooler assembly.

Features

It is fully compatible with the rest of the stealthburner system of hot ends & shrouds. A slightly modified version of the stealthburner fan shroud has been included to allow access to the orbiter filament lever.
Compatible with the Crown Cooler system.
Has a straight filament path.
Has an integrated filament sensor beneath the extruder for ERCF. Note that a filament sensor is not explicitly required anymore, but has been kept for legacy reasons.
Works with cable chains or canbus boards
Has a hinge feature integrated into the mount, to attach an aesthetic stealthburner shroud.

Gallery

Versions

Standard Canbus	PG7 Canbus	Cable Chain

Standard Mount	PG7 Cable Gland Mount	Standard Mount

There is a variation of the standard mount to incorporate a filament sensor below the extruder. See below.

Stealthburner Build

Crowncooler Build

Filament sensor (for the filament sensor version):

There are a few inherent issues with the sensored mount so I do not recommend them. I highly recommend using the sensorless mounts instead, along with the Happy Hare ERCF software.

If that answer doesn't satisfy you, there are a number of issues with the sensored mounts:

requires supports
sensor breaks the PTFE tube into two
needs a pretty well calibrated printer to get the tolerance on the ball bearing hole right
is actually LESS reliable than the sensorless version, as filament shavings from the extruder can work its way down into the ball bearing cavity, which jams it open
eventually the filament rubbing on the hole around the ball bearing starts to wear through it and enlarge it