SparkFun_TensorFlow_Apollo3_BSP

BSP and examples to integrate the SparkFun TensorFlow board with the AmbiqSuite SDK.

Associated Documentation

Edge Board Hookup Guide - Basic hookup guide for the SparkFun Edge.
Software Development Kit (SDK) Setup Guide - Software Development Kit for working with the SparkFun Edge.

Clone or download then extract or symlink this repo into the SDK/boards/ directory.

This repo contains several example projects.

example1_edge_test demonstrates the hardware features of the board. The makefile is preconfigured with relative paths.
- To compile with gcc and flash use the makefile in the gcc subdirectory.
  - Edit 'COM_PORT' variable to specify where to try UART flashing
  - make
  - make clean
  - make bootload
example2_dual_mic_dma shows how to use DMA to capture 16 kHz audio recordings from both microphones without blocking the processor. This is the basis of how audio is provided to the TensorFlow Lite demo.
tensorflow_demo uses a pre-trained model to identify "yes" and "no" and blink a corresponding LED on the board. Using GPIO you could easily expand this example to control a device.
SparkFun_Edge_Project_Template has a relatively easy to set up makefile with some example header files and source files included. You can copy this directory to an arbitraty location on your filesystem to begin a new project.
- You must provide the absolute path to the SDK root directory in the 'SDKPATH' variable
- Also update the COM_PORT variable to match your setup