Gripper

Simple and easy to use screenshot utility for Wayland for just works out-of-the box experience

Gripper is an alternative to grimblast and grimshot that works for both Hyprland and Sway.

Gripper runs grim under the hood, but makes it easier to use by providing "alias" of common operations that are often compositor-specific. Also copies captured image to clipboard and sends notification on completion by default.

Modes

Mode is a common screenshotting operation that is bundled into a single subcommand. Some modes are compositor-specific such as active-window, but Gripper will run the correct command intended for each compositor respectively.

These are the modes that are implemented, these can be run as gripper <mode>:

full: Fullscreen (focused/selected monitor).
region: Select a region using slurp. The region selection is free if you hold and drag, but if you use supported compositors it also has window snapping which highlights the window your cursor is currently in and automatically select the region occupied by the window by just clicking on it.
active-window: Screenshot the window currently focused (needs supported compositor).
last-region: The region selected by previous execution of region, active-window and custom mode.
custom: Specify the region to capture yourself.

Compositors

Gripper should run on compositors that grim and slurp support.

Some modes such as active-window require them to be implemented for specific compositor.

Supported compositor means that some compositor-specific operations are implemented for that compositor.

Supported compositors for now:

Hyprland
Sway

Prerequisites

Make sure the following commands are available.

grim
slurp
jq
wl-copy (optional, for copying image to clipboard)
notify-send (optional, for notification)

You can check them with the program by running gripper --check.

Building

Gripper is written in pure C without any external libraries. Install meson then run these commands:

$ meson setup build
$ meson compile -C build
$ ./build/gripper --help

Nix (with Flake)

Simply run the following commands.

$ nix build
$ ./result/bin/gripper --help

All the required programs should be available to the program but check if your notification daemon supports sending notification through notify-send.