sqfmi/beepy-hardware

Issues

• Gerber and Boom

  #25 opened 4 months ago by clarax98
  0

• Place for LTE module

  #24 opened a year ago by wowatatarin
  1

• V1 Case needs a power slide button

  #17 opened a year ago by 57Bravo
  5

• Add a clear qwerty key mapping to docs

  #18 opened a year ago by 57Bravo
  3

• Rename description

  #23 opened a year ago by dezren39
  1

• The slim case's thickness is too thin

  #22 opened a year ago by dishangti
  0

• Slim case — Lower front two screw holes do not fit the screw part suggested

  #20 opened 2 years ago by jogloran
  3

• Add a piezo element for audio in Rev A HW

  #19 opened 2 years ago by 57Bravo
  2

• Expansion I/O mechanically interferes with SDCARD/MIPI jacks

  #12 opened 2 years ago by 57Bravo
  3

• Misc hardware notes

  #15 opened 2 years ago by jamesmunns
  2

• Make display modular in V2

  #14 opened 2 years ago by 57Bravo
  0

• Create a CM4 carrier for V2

  #13 opened 2 years ago by 57Bravo
  1

• Create a LoRa transceiver add-on in v2

  #8 opened 2 years ago by 57Bravo
  6

• Consolidate expansion I/O into single stackable header in v2

  #6 opened 2 years ago by 57Bravo
  2

• Flip the RPI in v2 and use ground plane to heat sink the CPU

  #7 opened 2 years ago by 57Bravo
  0

• Add prototyping area to PCB

  #11 opened 2 years ago by sockbot
  0

• Add a space for the rear case to accept an RPi camera

  #1 opened 2 years ago by sockbot
  2

• Add space in the enclosure for gpio daughter cards

  #4 opened 2 years ago by 57Bravo
  0

• Add kicad files

  #2 opened 2 years ago by 57Bravo
  2

• Publish 3D models for v1 enclosure in STEP or IGES format

  #5 opened 2 years ago by 57Bravo
  2

• Create an enclosure case for TPU prints

  #3 opened 2 years ago by 57Bravo
  2