WIP A MotionEye server deployed on resin.io.
- Navigate to the device's IP/hostname over
http
to open the interface - Alternatively enable the public device URL, and navigate to that to see the interface
The interface uses the default MotionEye credentials. There you can add your settings (cameras, etc) that are stored in a non-volatile way (in docker volumes).
To use an attached PiCamera, check our documetation for settings it up, and use gpu_mem
set at least to 192
.
Some device settings can be adjusted with Device/Fleet service variables. These should be set for the motioneye
service:
SERVER_NAME
: the name of the server in the MotionEye UI. If not set, then the device's name (from theRESIN_DEVICE_NAME_AT_INIT
variable) will be used automatically.TIMEZONE
: the device's local time, one of the timezone names from the available time zones. If not set, the default UTC time is used.
- The current setup only supports ARMv7 devices (especially Raspberry Pi 3). Other device types are WIP
- The default
docker-compose.yml
exposes 10 MotionEye camera streaming ports on the port range used by MotionEye by default (8081-8090
), if need more than that, you need to edit the compose file.