This is an example to quickly handle an On/Off Light Device with On/Off Light Switch. The project generates a Zigbee Light Device acting as a Router (ZR) and Zigbee Light Switches as End Devices(ED). It is a good introduction to handle and have a first approach of ST Zigbee mesh solution.
For more details, please refer to Wiki Zigbee RUC Lighting
This example uses the RGB Led on the STM32WB5MM-DK board as a dimmable light and the P-NUCLEO-WB55 board as light switch. After binding the light bulb with light switch(es), you can control OnOff and level.
For more information on the boards, please visit P-NUCLEO-WB55 Pack and STM32WB5MM-DK Pack
The following applications are running on the P-NUCLEO-WB55 boards:
- Zigbee_Coord
- Zigbee_Light_Switch
- Zigbee_Occupancy_Sensor (possible extension of the network)
- Zigbee_OnOff_Sensor (possible extension of the network)
The following application run on the STM32WB5MM-DK board:
- Zigbee_OnOff_Light
The applications Zigbee_Coord and Zigbee_OnOff_Light require having the stm32wb5x_Zigbee_FFD_fw.bin binary to be flashed on the Wireless Coprocessor. All others applications require having the stm32wb5x_Zigbee_RFD_fw.bin binary. If it is not the case, you need to use the STM32CubeProgrammer to load the appropriate binary. For the detailed procedure to the Wireless Coprocessor binary see following wiki for hardware setup STM32WB Build Zigbee project
In order to make the programs work, you must do the following:
- Open your toolchain
- Rebuild all files and flash the board with the executable file
For more details refer to the Application Note : AN5289 - Building a Wireless application
For Zigbee_Occupancy_Sensor and Zigbee_OnOff_Sensor application, a 3-pin PIR sensor is needed like PIR Parallax
To install the RUC Lighting, please follow the HowTo Join a Zigbee Network and HowTo bind devices
Caution : Issues and the pull-requests are not supported to submit problems or suggestions related to the software delivered in this repository. The STM32WB-ZB-RUC-Lighting example is being delivered as-is, and not necessarily supported by ST.
For any other question related to the product, the hardware performance or characteristics, the tools, the environment, you can submit it to the ST Community on the STM32 MCUs related page.