-
The STM32WB55ADV-Tester project uses the NUCLEO-WB55RG board to simulate multiple Bluetooth devices nearby.
Every 0.2s, the STM32WB55 increments its public Bluetooth address
00:00:00:00:00:01
00:00:00:00:00:02
00:00:00:00:00:03
...
You can use the STM32WB55 to test the Bluetooth scanner side.
- One NUCLEO-WB55RG
- One Bluetooth scanner such as smartphones or laptops
-
IDE, choose your preferred one:
-
STM32CubeIDE - please use high code optimization level
-
Keil MDK-ARM - please use high code optimization level
-
-
Bluetooth scanner side
- Bluetooth smartphone apps like ST BLE Toolbox
- Another NUCLEO-WB55RG with P2P Client app
- STM32CubeMon-RF
-
Build this STM32WB55ADV-Tester project using one of the IDEs.
-
Flash this code on the NUCLEO-WB55RG board and check the LEDs. LED1: Briefly turns off when stopping BLE advertising. Turns on after reconfiguring BLE public address and ADV packet. LED2: Toggles at the end of Radio activities.
-
Use the Bluetooth scanning app to test like the ST BLE Toolbox mobile app
Caution : Issues and the pull-requests are not supported to submit problems or suggestions related to the software delivered in this repository. The motor parameters are not optimized in this firmware. The STM32WB55ADV-Tester example is being delivered as-is, and not necessarily supported by ST.
For any other question related to the product, the hardware performance or characteristics, the tools, the environment, you can submit it to the ST Community on the STM32 MCUs related page.