stuartpittaway/diyBMS
Do it yourself battery management system for Lithium ion battery packs/cells
C++GPL-3.0
Issues
- 0
- 2
Temp calibration
#26 opened by hepike - 4
- 0
- 0
Atmega328 conversion
#34 opened by danpshyco - 1
Missing R5 from BOM
#33 opened by jchengz - 3
When was R5 removed?
#31 opened by Alpha-IT-Centre - 3
ESP32 diyBMS
#22 opened by fjgaston - 1
Am I blind, where is R11?
#29 opened by codemonkey76 - 2
Confused
#27 opened by mikegleasonjr - 11
J1, C6 and C1 are very close on the PCB (v2.1)
#20 opened by fjgaston - 8
- 2
ATTiny acting weird
#24 opened by fjgaston - 2
documentation
#7 opened by tvixen - 9
The direction of ALUM1250
#8 opened by tvixen - 4
why 3.3V for the ATTiny ?
#18 opened by fjgaston - 5
- 26
ESP code conver to Arduino Uno code
#10 opened by EmreBostanci - 13
BOM updated
#14 opened by ArchGalileu - 1
DIY BMS Stencil for 3D printing
#17 opened by PapaStauth - 1
Thermistor voltage divider in cold weather
#16 opened by stuartpittaway - 0
The term “Ground” on the cell module is not correct, it should be “Bat -”
#15 opened by stuartpittaway - 1
Qi Charger for DC/DC Isolation and Dump Load?
#13 opened by jamestutton - 1
Not compiling under Linux
#12 opened by delboy711 - 4
Is resistor R2 too low?
#6 opened by stuartpittaway - 2
ATTINY85 pcb footprint is too small
#1 opened by stuartpittaway - 3
ADUM1251 footprint slightly too wide
#2 opened by stuartpittaway - 3
Change capacitors to 1206 SMD sizes
#4 opened by stuartpittaway - 4
PCB works - almost!
#3 opened by stuartpittaway