This README file contains information on the contents of the
laird-cp layer.
Please see the corresponding sections below for details.
Dependencies
============
This layer depends on:
URI: git://git.openembedded.org/bitbake
branch: master
URI: git://git.openembedded.org/openembedded-core
layers: meta
branch: master
URI: git://git.yoctoproject.org/xxxx
layers: xxxx
branch: master
Patches
=======
Please submit any patches against the laird-cp layer to the e-mail:
cs-support@lairdtech.com
Table of Contents
=================
I. Adding the laird-cp layer to your build
II. Misc
I. Adding the laird-cp layer to your build
=================================================
--- replace with specific instructions for the laird-cp layer ---
In order to use this layer, you need to make the build system aware of
it.
Assuming the laird-cp layer exists at the top-level of your
yocto build tree, you can add it to the build system by adding the
location of the laird-cp layer to bblayers.conf, along with any
other layers needed. e.g.:
BBLAYERS ?= " \
/path/to/yocto/meta \
/path/to/yocto/meta-poky \
/path/to/yocto/meta-yocto-bsp \
/path/to/yocto/meta-laird-cp \
"
II. Misc
========
This layer provides the following modules:
- Sterling 60 Wi-Fi driver and firmware
- Sterling WPA supplicant
- Laird NetworkManager
- To use Wi-Fi driver add "backports-laird" and appropriate firmware recipe
to your image
1. Remove cfg80211 and mac80211 from the kernel config
2. Explicitly add the cfg80211 and mac80211 dependencies to the kernel config
- To use Sterling WPA Supplicant add "sterling-supplicant" recipe to your
image, and in local.conf or <disto>.conf add the following:
PREFERRED_PROVIDER_wpa-supplicant-cli = "sterling-supplicant"
PREFERRED_PROVIDER_wpa-supplicant-passphrase = "sterling-supplicant"
- To use Laird Network Manager add "laird-networkmanager" recipe to your image