MACCHIATObin Fan daemon
The MACCHIATObin board has a PWM fan connected to the J10 header.
By default the fan spin at maximum speed, but it can be switched on/off via GPIO #80 (precisely GPIO #16 of the second chip).
mcbinfand
mcbinfand is a small daemon which reads the temperature from the armada-cp110-thermal" hwmon iterface, and sets the fan speed via a software PWM.
The fan duty cycle is set at 0% with temperature below 40 °C and 100% when temperature goes above 55 °C.
For temperatures in the middle, duty cycle is scaled proportionally.
Compiling
mcbinfand only depends on libgpiod
Running
mcbinfand is not configurable at runtime yet, if you want to tune it, set these variables in fand.c:
- MIN_TEMP the min temperature, e.g. the one with 0% duty cycle
- MAX_TEMP the max temperature, e.g. with 100% duty cycle
- PWM_USECS the interval in microseconds of the PWM loop. Lower values will keep the CPU busy
On exit the daemon will leave the GPIO on, so the fan will spin at maximum speed and your CPU won't burn.
fand.service is a systemd unit file which starts the daemon just after the creation of the /dev/gpiochip1 character device.