Sensirion control PCB adjustments
Burhan-Q opened this issue · 3 comments
Burhan-Q commented
Phoenix connector needs to move inboard to avoid issues with mounting to Sensirion sensor.
Needed for Issue #67
Current distance (center to center):
Phoenix pins to pogo pins = 9.705mm
Phoenix pins to board face = 6.721mm
Constraints:
Distance pogo pins to front of sensirion cut out = 9.597mm - 0.862mm = 8.735mm [bumpouts on inside of Sensirion cutout]
Phoenix connector to control board PCB component = 1.938mm (max distance phoenix connector can move backwards, see image below)
Image of interference
Pogo pins to front wall (subtract 0.862mm for bump-out, center to edge)
Current space between pogo pins and phoenix connector pins (center to center)
Current phoenix pins to board (center to face):
Phoenix pins to Sensirion PCB component:
Second view:
Space between rear of (current) phoenix connector to control board PCB component:
Burhan-Q commented
Uploaded these to Slack, but also posting them here
STEP_files_requested.zip
Burhan-Q commented
Pogo pins and phoenix connector pins
Center to center distance on @mechatroniks-git board model = 8.43mm
Phoenix connector pins to board face
hydronics2 commented
@Burhan-Q ... created a pull request with the new files. thanks for the pics!... and that fusion 360 model is worth a 1000 words.