######################################################
###################################################### Contains a diptrace schematic (.dch) and pcb layout (.dip) file for the CC3100MOD Wifi Wireless Network Module. Not yet built or tested!
- Powered by 3.3V
- Can communicate with a host MCU over standard SPI or UART hardware flow control (See "Header Pins" section below)
- Sleep (hibernate) Mode allows for minimum power consumption when not in use
##Schematic:##
- Bill Of Materials
- 1 CC3100MOD Wifi Wireless Network Module
- 1 AH316M245001-T Antenna
- 1 1.0pF capacitor
- 1 3.6nH inductor
- 2 10kOhm resistors
- 1 100kOhm resistor
- 2 10 pin header strips
##Board Layout:##
-
DRC Notes
-
A number of DRC rules about spacing are located in the antenna section of the layout.
-
These DRCs are flagged because the FEED pin is connected to the GND plane (needed to create the inductive stub to cancel out the antenna's capacitance)
-
Refer to section 6.3 of the datasheet (http://www.ti.com/lit/ds/symlink/cc3100mod.pdf)
-
Dimensions
-
Rectilinear Outline
-
X: 960 mils
-
Y: 1297 mils
-
W/ Two Triangular "Cutouts" On Top
-
X: 299 mils
-
Y: 257 mils
-
Header Pins (From Top To Bottom)
-
Left Hand Side:
-
H1-1: VDD_3V3 (TI Pins 36, 37, 40)
-
H1-2: UART_TX (TI Pin 46)
-
H1-3: UART_RX (TI Pin 27)
-
H1-4: NC
-
H1-5: /RESET (TI Pin 35)
-
H1-6: /WAKE (TI Pin 4)
-
H1-7: NC
-
H1-8: NC
-
H1-9: NC
-
H1-10: GND (TI Pins 1, 2, 26, 27, 28, 30, 32, 38, 43, 55-63)
-
Right Hand Side:
- H2-10: HOST_INTR (TI Pin 11)
- H2-9: NC
- H2-8: SPI_SCLK (TI Pin 5)
- H2-7: /SPI_CS (TI Pin 8)
- H2-6: UART_CTS (TI Pin 51)
- H2-5: NC
- H2-4: NC
- H2-3: SPI_MISO (TI Pin 7)
- H2-2: UART_RTS (TI Pin 44)
- H2-1: SPI_MOSI (TI Pin 6)