Simple current probe pcb for use with eurorack and motm synthesizer modules.
Makes it easy to place a current meter in series with power headers. Also makes it easy to power a module with a current-limited lab power-supply. Make sure to jump any power rails which are not in use for measurement.
Currently there are 2 versions. V1 - for eurorack modules only and V2 - for eurorack and motm modules.
V1
BOM - V1
2 x shrouded 2x8 2.54mm pin header
1 x unshrouded 2x8 2.54mm pin header
7 x 4 mm banana jack
5 x 2.54mm jumpers
optional 4 x M3 standoff (+ m3 screws or nuts)
V2
BOM - V2
2 x shrouded 2x8 2.54mm pin header
2 x 4 pin MTA-156 pin header
1 x unshrouded 2x8 2.54mm pin header
7 x 4 mm banana jack
5 x 2.54mm jumpers
optional 4 x M3 standoff (+ m3 screws or nuts)
<----------------------------------------------------------------------------------------------------------------------------->
Copyright (c) 2016 Thomas Hopman
This documentation describes Open Hardware and is licensed under the CERN OHL v. 1.2. You may redistribute and modify this documentation under the terms of the CERN OHL v.1.2. (http://ohwr.org/cernohl). This documentation is distributed WITHOUT ANY EXPRESS OR IMPLIED WARRANTY, INCLUDING OF MERCHANTABILITY, SATISFACTORY QUALITY AND FITNESS FOR A PARTICULAR PURPOSE. Please see the CERN OHL v.1.2 for applicable conditions