Description:
This is a code example demonstrating FLIR Boson camera command and control using Boson SDK commands. It's written for interface with a Linux system and performs the following commands in sequential order:
- Connects to the camera
- Reads and displays the Camera Serial Number
- Reads and changes the bit depth of the output
- Reads and displays the current Software Revision of the Camera
- Reads and displays the Sensor Part Number
- Reads data from the Camera Flash
- Gets the current Frame Count
- Changes the FFCMode to Manual, then back again
- Performs a manual FFC
To compile
First, compile by running
./build.sh
To run:
Run example_linux in the examples directory after compiling.
Obtain processor temperature
./examples/boson_cpu_temp
Obtain sensor temperature
./examples/boson_fpa_temp
Run multiple examples
./example_linux
Build Notes
This was built on tested with Boson SDK rev 2.0.5. 2.0.5 is included, but the latest SDK can be found at https://www.flir.com/support/products/boson#Resources