Old EEPROM & Flash settings used
maxledfreak opened this issue · 3 comments
maxledfreak commented
Hello,
before installing MCLighting on my node mcu (e12), EasyESP was installed. Settings are saved in EEPROM ans Flash. After flashing MCLighting, the main log in page does not start.
Proposal for implementing in code: erase flash and EEPROM complete. Then it should works.
greetings
max
toblum commented
Hi @maxledfreak,
thank you for your feedback. I will check that, but I'm not sure if that can be accomplished via code.
Regards
Tobias
maxledfreak commented
Hello Tobias,
just have a look in EasyESP Code. It works ;-)
Max
toblum commented
Hi,
Thanks, I will have a look at it. I added it to the ToDo list.
Regards
Tobias