Wemo Switch

This plugin allows for the control of Belkin Wemo devices via navbar buttons and gcode commands.

Screenshots

Settings

Once installed go into settings and enter the name of your wemo device. Adjust additional settings as needed.

IP Address
- The IP address of the wemo device.
Label
- Label to use for title attribute on hover over button in navbar.
Icon Class
- Class name from fontawesome to use for icon on button.
Warn
- The left checkbox will always warn when checked.
- The right checkbox will only warn when printer is printing.
GCODE
- When checked this will enable the processing of M80 and M81 commands from gcode to power on/off plug. Syntax for gcode command is M80/M81 followed by the plug's ip address. For example if your plug's IP address is 192.168.0.104 your gcode command would be M80 192.168.0.104
- Added with version 0.1.2 you can now use the custom action commands @WEMOON and @WEMOOFF followed by the IP address of the plug. For example if your plug's IP address is 192.168.0.104 your gcode command would be @WEMOON 192.168.0.104. This option will only work for plugs with GCODE processing enabled.
postConnect
- Automatically connect to printer after plug is powered on.
- Will wait for number of seconds configured in Auto Connect Delay setting prior to attempting connection to printer.
preDisconnect
- Automatically disconnect printer prior to powering off the plug.
- Will wait for number of seconds configured in Auto Disconnect Delay prior to powering off the plug.
Cmd On
- When checked will run system command configured in System Command On setting after a delay in seconds configured in System Command On Delay.
Cmd Off
- When checked will run system command configured in System Command Off setting after a delay in seconds configured in System Command Off Delay.

Get Help

If you experience issues with this plugin or need assistance please use the issue tracker at the top of this page.

Additional Plugins

Check out my other plugins here

Support My Efforts

I, jneilliii, programmed this plugin for fun and do my best effort to support those that have issues with it, please return the favor and leave me a tip if you find this plugin helpful.