CreawsomeMod-4.1.0 Z Seam Alignment - Sharpest Corner don't work

Question

CreawsomeMod-4.1.0 Z Seam Alignment - Sharpest Corner don't work

Closed this issue 5 years ago · 5 comments

Hello,
Cura doesn't always start at a corner with CreawsomeMod-4.1.0 (CreawsomeMod-4.1.0.mod20190530-0.3.2-x86_64.AppImage i use the Linux AppImage).
I am currently printing https://www.thingiverse.com/thing:73489
penholder.stl
04-14-13
82927 29mb

Starting point 1 is ok.
But at 2 it starts in a curve.

Settings:
Dynamic Quality - 0.16mm
Z Seam Alignment - Sharpest Corner
Infill 15% - Gyroid
Printing Temperature - 220°C
Build Plate Temperature - 55°C
Build Plate Adhesion - Brim

Many greetings

metekaanh commented 5 years ago

Try This

Answer 1 · 2019-07-15T18:08:08.000Z

I have test user Specified.
The seam is then in the middle of the printed object.

Or is Z seam y 90 decisive?

Thank you very much for help

Answer 2 · 2019-07-15T19:26:51.000Z

I think try both a minimal same parts and give your decision but my idea is y 90

Answer 3 · 2019-07-15T21:02:04.000Z

Thank you very much.

Answer 4 · 2019-07-16T10:06:41.000Z

The Y=90 is just an example to show how you can move to a corner

Seam corner preference is only effective when there is a corner on the layer. Totally curved parts don't have any corner.

With regards to the pig, the seam splits in two where you can't have a single perimeter. The ears are basically two separated circles at this point.

Cura just tries to place the seam as close as possible to the X/Y positions configured and to fulfill corner preference. Hence I set it to "None" to only use X/Y positions.