My personal OpenCore EFI

How I use this repo

This repo is for versioning bootloader on my Hackintosh computer including binaries, kexts, config.plist.

Issues relating to macOS, OpenCore: Issues
Knowledge: Wiki

Hardware specs

Intel Core ~~i5 10600k~~ i7 10700k
Gigabyte Z490 Aorus Elite
G.SKILL Ripjaws V DDR4 3000MHz 4x8GB
Gigabyte Aorus Radeon RX 5700XT 8G
WD_BLACK SN750 NVMe SSD 512GB
Audio Realtek ALC1200 codec
LAN Realtek 2.5GbE
Wifi Broadcom BCM943602CS
Noctua NH-U14S
NZXT H510

What works

Wifi runs perfectly without injecting any kexts
CPU virtualization with Docker
Front & rear USB ports using tool from corpnewt/USBMap (some ports can't map as 2.0 cause reach 15 ports limit)
Bluetooth (after USBMap)
Magic Mouse 2 & BeatsX Wireless Earphones
TRIM support out-of-box
GPU temperature sensors (read through iStat Menus)

Limitations:

After wakeup from sleep, Bluetooth services are frozen for a few minutes, and the system becomes unstable: can crash, unable to shut down...

Cloning

git init
git remote add origin git@github.com:tuanht/hackintosh-10600k-z490-aorus-elite-5700xt.git .
git pull --set-upstream origin master
git submodule update --init --recursive

Install

Just type make install to download OpenCore and ACPI/drivers/kexts for configured version.

Cleanup

Type make clean to clean up any downloaded files to make your EFI folder structure look clean.

Bootable USB Installer (WIP)

If you're installing EFI for USB Installer, you'll want to display console messages during boot for troubleshooting. I've made a special target that can run after install to enable verbose mode in config.plist, just run: make install_usb.

Disclaimer

This OC build is made specifically for my system. Don't use it unless you understand which configurations need to be changed to suit your need. Checkout merged PRs for some important changes.