mccGetData
Custom program for sampling data from Measurement Computing DAQ. Originally intended for USB 1608-FS Plus onboard a UAV Compiled using Visual Studio 2017 on Windows 10
Replaced in July 2018 with BC5-datalogger, a version that combines this program with vectorNavGetData and runs on a Raspberry Pi.
Usage
- Place Project1.exe in the same directory as a config.txt file. Double-click the executable to begin.
- config.txt must contain the following fields in this order, seperated by tabs:
- Sampling Rate (integer, in hertz. Must be less than 100kHz)
- Number of Channels to Sample (Aggregate sample rate cannot exceed 400kHz)
- Voltage range (1,2,5, or 10)
- Duration of sampling period (in minutes)
- A copy of the config data for the session is saved at configdataXX.txt, where XX is some number between 00 and 99
- Raw data will be ouput as dataXX.daq , where XX is same number from configdata
- At the end of the session, the actual configuration that was run is saved at confirmdataXX.txt. This should match configdataXX.txt
- Raw data will be saved even if the session is interrupted, but confirmdataXX.txt is only created at the end of a session.