/pi-power-button

Scripts useful for the Pi power button

Primary LanguageShell

pi-power-button

Scripts used in our official Raspberry Pi power button guide.

Installation

  1. Connect to your Raspberry Pi via SSH
  2. Clone this repo: git clone https://github.com/Howchoo/pi-power-button.git
  3. Run the setup script: ./pi-power-button/script/install

Uninstallation

If you need to uninstall the power button script in order to use GPIO3 for another project or something:

  1. Run the uninstall script: ./pi-power-button/script/uninstall

Hardware

A full list of what you'll need can be found here. At a minimum, you'll need a normally-open (NO) power button, some jumper wires, and a soldering iron. If you don't have a soldering iron or don't feel like breaking it out, you can use this prebuilt button instead.

Connect the power button to Pin 5 (SCL) and Pi 6 (GND) as shown in this diagram:

Connection Diagram