/PrusaSlicer-FlashForge

PrusaSlicer Configuration Flashforge Printers

Primary LanguageG-codeMIT LicenseMIT

ONLY WORKS ON PRUSASLCIAER 2.4+

Install python3 Import Config Bundle edit path to script

Export config Bundle

FlashForge Creator 3 GCode

G Codes

G1 X Y Z F ; Move G90 ; absolute positioning G91 ; relative positioning G92 E0 ; reset extrusion distance G162 Z F1800 ; Go to max Z position

M Codes

M6 T0 ; wait for extruder temp M7 T0 ; wait for platform temp M18 ; disable steppers M104 S{first_layer_temperature[0]} T0 ; set right extruder temp M104 S{first_layer_temperature[1]} T1 ; set left extruder temp M106 ; Extruder/Heat Break fan on M107 ; Extruder/Heat Break fan off M108 T{initial_extruder} ; tool change M118 X150.00 Y125.00 Z200.00 T[initial_extruder] ; todo: need to post process this M140 S[first_layer_bed_temperature[initial_extruder]] T0; set bed temperature M651 S[0-255]; chassis fan on M652 ; chassis fan off

T Values

Extruder Commands:

  • T0: Right Extruder
  • T1: Left Extruder

Bed Commands

  • T0: Bed

FlashForge Creator 3 Reference

Here's some useful information that's not clear when operating the Creator 3:

  • Z Calibration Expert Mode:
    • ZCAL: Extra distance from right nozzle to bed zero.
      • Positive values mean the right nozzle is lower than the mechanical "zero" point and is too close to the bed.
      • Increasing to be more positive adds more gap between right nozzle and bed
    • ZDIFF: Offset of left nozzle relative to right nozzle.
      • Positive values mean the left nozzle is lower than right nozzle.
      • Increasing to be more positive adds more gap between the left nozzle and the bed when that nozzle is active.