ndpresponder is a Go program that listens for ICMPv6 neighbor solicitations on a network interface and responds with neighbor advertisements, as described in RFC 4861 - IPv6 Neighbor Discovery Protocol.
This program differs from ndppd - NDP Proxy Daemon in that the source IPv6 address of neighbor advertisement is set to the same value as the target address in the neighbor solicitation. This change enables ndpresponder to work in certain KVM virtual servers where NDP uses link-local addresses but ebtables drops outgoing packets from link-local addresses. See my blog post for more information.
This program is written in Go. It requires both Go compiler and C compiler. You can compile and install this program with:
go install github.com/yoursunny/ndpresponder@latest
This program is also available as a Docker container:
docker build -t ndpresponder 'github.com/yoursunny/ndpresponder#main'
docker run -d --name ndpresponder --network host ndpresponder [arguments]
The program can respond to neighbor solicitations for any address under one or more subnets. It's recommended to keep the subnets as small as possible.
Sample command:
sudo ndpresponder -i eth0 -n 2001:db8:3988:486e:ff2f:add3:31e3:7b00/120
-i
flag specifies the network interface name.-n
flag specifies the IPv6 subnet to respond to. You may repeat this flag to specify multiple subnets.
The program can respond to neighbor solicitations for assigned addresses in Docker networks. When a container connects to a network, it attempts to inform the gateway router about the presence of a new address.
Sample command:
docker network create --ipv6 --subnet=172.26.0.0/16 \
--subnet=2001:db8:1972:beb0:dce3:9c1a:d150::/112 ipv6exposed
docker run -d \
--restart always --cpus 0.02 --memory 64M \
-v /var/run/docker.sock:/var/run/docker.sock:ro \
--cap-drop=ALL --cap-add=NET_RAW --cap-add=NET_ADMIN \
--network host --name ndpresponder \
ndpresponder -i eth0 -N ipv6exposed
-i
flag specifies the network interface name.-N
flag specifies the Docker network name. You may repeat this flag to specify multiple networks.
You may change log level of this program by setting the NDPRESPONDER_LOG
environment variable.
Acceptable values are DEBUG
, INFO
, WARN
, ERROR
, and FATAL
.
Sample command:
sudo NDPRESPONDER_LOG=WARN ndpresponder [arguments]
docker run -e NDPRESPONDER_LOG=WARN [other arguments]