A simple 3d-printable oring gasket keyboard.
Depending on 3d print tolerances, plate and PCB edges might scratch against the corners of the case. Ideally, the outlines of both should be reduced a little bit. Unfortunately, these changes will not be done as a result of me losing interest in the project due to availability of Bakeneko.
The PCB is not compatible with other cases due to custom mounting point cutouts and USB position. In turn, the case is also not compatible with any third-party PCBs.
Around 180mm ID and 3.5mm CS, for example AS568-263 should work fine.
The case should be machinable, however it was not tested and I cannot suggest getting it machined due to extremely simplistic design (ie just make a Bakeneko instead).
This project is licensed under CC0, see the LICENSE file for more details, or tldrlegal.com for a summary.