Addons and configuration for 3D printers
Anycubic i3 mega S Klipper fast printing (first layer on 200 mm/s speed): https://youtu.be/GtIsCP1_Cyg
Klipper configuration file for Anycubic i3 mega S
This config file contains settings of all printer pins (steppers, sensors) for Anycubic i3 mega S in the factory configuration
Klipper firmware should be compiled for the atmega2560
Config file includes
- Configuration for original or 2208(2209), rotated by cabel, drivers
- Mesh bed leveling: BLtouch (3DTouch sensor from Triangelab)
- Manual meshed bed leveling (commented out)
- 'virtual_sdcard' for fast printing without gaps
- Beeper through M300 gcode
- Pause/Resume through M600 for filament change
Home position is determined by 3DTouch. Z limit switches are not used.
The latest version of the config reference is also available online at: https://www.klipper3d.org/Config_Reference.html
!!! Do not forget to check your configuration for: !!!
- step_distance
- nozzle_diameter
- pressure_advance
- serial
- [bltouch]
- [virtual_sdcard]
!!! Also important to follow all config check from this manual before start printing: https://www.klipper3d.org/Config_checks.html
Useful documentation for slicer/printer (not special for Klipper) calibration: https://teachingtechyt.github.io/calibration.html#intro