This repo contains the modifications and current configuration files for my Creality Ender 5 Plus.
The main board in this printer is an BTT SKR-Mini E3 V2.0.
The screen is still the stock screen. A custom cable was created so that it could work with the new main board via the TFT pins, see pinout below:
| LCD Pin | SKR Pin | Description |
|---|---|---|
| 1 | 5 | 5V |
| 2 | NC | |
| 3 | 3 | LCD RX / SKR TX2 |
| 4 | 2 | LCD TX / SKR RX2 |
| 5 | NC | |
| 6 | 4 | GND |
Photos of cable are available here: https://imgur.com/a/O3nix8B
Stock
Stock
Stock
Stock
Stock
Stock cooler, but klipper has been configured so that the fan only turns on when the temperature is set to 50°C or above. When the hot end turns off, the fan turns off once the temperature drops back below 50°C.
The stock enclosure fan was always on and very loud, so it was replaced with a 5V Noctua fan. It is connected to the SKR via the Neo Pixel port. It turns on and off automatically whenever the extruder or bed are turned on.
Klipper is loaded onto this printer, see printer.cfg
It is running on a Raspberry Pi 4B. Currently it is just sitting beside the printer, but will soon be mounted inside of the control box and powered from the SKR with a DCDC converter to drop the voltage to 5V.