/LimeSDR-USB

USB 3.0 version of the LimeSDR board

Primary LanguageANTLR

LimeSDR

LimeSDR board

The LimeSDR board provides a hardware platform for developing and prototyping high-performance and logic-intensive digital and RF designs using Altera’s Cyclone IV FPGA and Lime Microsystems transceiver.

  • USB Interface
    • Cypress FX3 super speed USB 3rd generation controller
  • FPGA Features
    • Cyclone IV EP4CE40F23C8N device in 484-pin FPGA
    • 39’600 logic elements
    • 1134 Kbits embedded memory
    • 116 embedded 18x18 multipliers
    • 4 PLLs
  • FPGA Configuration
    • JTAG mode configuration
    • Active serial mode configuration
    • Possibility to update FPGA gateware by using FX3 (USB)
  • Memory Devices
    • 2x 1Gbit (64M x 16) DDR2 SDRAM
    • 4Mbit flash for FX3 firmware
    • 16Mbit flash for FPGA gateware
    • 3x 64K (8K x 8) EEPROMs for LMS MCU firmware, LMS MCU data and FX3 data
  • Connections
    • 6-12V DC power jack
    • FPGA GPIO headers
    • Micro USB3.0 (type B) connector or USB3.0 (type A) plug
    • Coaxial RF (U.FL) connectors
  • Clock System
    • 30.72MHz ±250 ppb on board VCTCXO
    • Possibility to lock VCTCXO to external clock or tune VCTCXO by onboard DAC
    • Programmable clock generator for the FPGA reference clock input or LMS PLLs
  • Board Size 60mm x 100mm (2.36” x 3.94”)

Contents

The directory structure is as follows:

  fx3/                       - Cypress FX3 USB 3.0 controller firmware
     
  gateware/                  - Altera Cyclone IV FPGA project

  hardware/<variant>/<version>/
      Libraries/             - Component Libraries
      OutputJobs/            - Output jobs
      PCB/                   - PCB design
      Project Outputs/       - BOM, rule check reports, Gerbers, pick & place files, PDFs
      Schematics/            - Schematic diagrams

Licensing

Hardware

The hardware designs are licensed under a Creative Commons Attribution 3.0 Unported licence.

FPGA design

For details of the FPGA design licensing please see the associated COPYING file(s). However, please note that this does not extend to any files provided with the Altera design tools and see the relevant files for the associated terms and conditions.

FX3 firmware

For details of the FX3 firmware licensing please see the associated COPYING file(s) and file headers.