TipTapMotor
Print one of each STL, except for:
- "GearBoxAssy-Planet.STL", which needs a total of three.
- "SingleMotorPCBspacer.STL", which is optional, but needs a total of two. Note: I used the LulzbotMini_TipTap.curaprofile on my lulzbot mini to get the tight tolerances needed on the gears and good first layer resolution.
Purchased Parts:
- Qty 1. DirectServo pcb: https://github.com/DarrenLevine/DirectServo/tree/master/Manufacturing
- Qty 3. 18-8 Stainless Steel Dowel Pin, 1mm Diameter, 12mm Length (hammered into the three holes of the "GearboxFace-LowerInner.STL")
- Qty 15. 96817A156 Thread Forming Screw for Thin Plastic
- Qty 1. iPower GBM3506H-130T Gimbal Brushless Motor
- Qty 4. M3x10mm Nylon bolt and nut (for PCB mounting)
- Qty 2. M3x6mm Nylon bolt and nut (for motor mounting)
- Qty 1. 6705 Thin Section Metric Ball Bearing Open 25x32x4
- Qty 3. 623ZZ 3mm x 10mm x 4mm Shielded Deep Groove Precision Ball Bearings
- Qty 3. Flat Head Screws M3 x 0.5 mm Thread, 6 mm Long (91420A116)
- Qty 1. Small diametric encoder magnet such as: https://www.kjmagnetics.com/proddetail.asp?prod=d82dia
Assembly according to cross section:
Final product:
