IDLE states on ducted unit
JeromeChignola opened this issue · 2 comments
Hello.
First of all, my English is bad (sorry, I'm French).
I got a document from panasonic that could probably interest you.
Then, I have been using your dev for a few months. The problem that I encounter is the following: on my ductable, I will need to recover the "idle" state because I have a regulation by zone.
Do you think it's possible?
Questions fréquentes.ppt - Mode de compatibilité.pdf
Can you define what you mean with "idle state"?
Can you give an example of what you're trying to accomplish?
By "idle state" I mean when the duct is on but not heating. When it has reached the set temperature for example.
I am trying to optimize my regulation by zone but the duct starts far too often.
Ideally, I am looking to shunt the value of the return temperature sensor