/xrpwifidrive

control xrp robot over websockets based on https://github.com/AdrianCX/crawlspacebot

Primary LanguageHTML

xrpwifidrive

setup

  1. using xrpcode, connect to device, update firmware (if prompted) and write all files to device (file > new file)
  2. update secrets.json with robot_id (it cannot collide with another)
    • optionally update config.py to change wifi information
  3. select code.py and run it
  4. now you should be able to disconnect from usb and it should keep running after power cycle (board "reset" button)
  5. connect to network ssid with password (see config.py)
    • you might need to disable cellular or prevent disconnecting from the network
  6. navigate to http://192.168.4.1:80 on the device, there should be a joystick
  7. use joystick for drive, slider for arm servo
    • if controls don't work, try reloading the page or pressing "reset" on the device