Lora-net/lora_gateway
Driver/HAL to build a gateway using a concentrator board based on Semtech SX1301 multi-channel modem and SX1257/SX1255 RF transceivers.
CNOASSERTION
Issues
- 2
- 6
Documentation about HAL library
#184 opened by Rynxie - 1
gateway sx1261 LBT
#183 opened by binbinskywalker - 2
Upgrade to kernel 5.4.51-v7+ breaks Raspberry Pi Hats that use SPI and expect GPIO 7 to be free
#162 opened by ludionisio - 6
- 2
Gateway frequency selectivity
#145 opened by eoinoconnell87 - 3
- 2
Receive uplinks & downlinks
#157 opened by MrKoppot - 1
SPI Issues
#158 opened by MartBent - 2
- 1
Packet Arbiter Firmware
#161 opened by Bustel - 2
Cross compilation error in Lora_gateway
#166 opened by George-Ng2020 - 1
Get parity error of Hamming decoding
#167 opened by kangyang73 - 1
XTAL error calc not using NAV-TIMEGPS
#168 opened by pshep - 2
"ERROR: failed to load fw 1", "ERROR: Version of calibration firmware not expected, actual:0 expected:2"
#169 opened by klarparatstart - 2
- 1
Listen Before Talk with 128 us scan time does not allow tx of 400ms duration
#171 opened by reissjason - 1
ERROR:SPI READ FAILURE
#176 opened by oziesin - 1
Stand-Alone LoRa Repeater
#177 opened by rogeriocassares - 1
- 1
help with concentrator
#179 opened by Jaimel1205 - 1
Need help with setup
#182 opened by AnandShastry - 0
Unix socket
#175 opened by LucasTERRIER - 1
Globally Unique EUI ??
#174 opened by qbaj - 3
Debugging lgw_send (not sending)
#155 opened by wavesoft - 1
- 1
ERROR: Version of calibration firmware not expected, actual:62 expected:2
#153 opened by kevin-malter - 2
- 1
FSK mode register explanation
#152 opened by hukm - 1
Led flashses on ic980a but no packet received
#151 opened by eoinoconnell87 - 1
Stand-alone modems SX127x supported
#150 opened by KachPro - 2
util_tx_continuius TX power level control
#149 opened by hamersin - 2
Cannot communicate with iC880 concentrator board
#132 opened by koppa - 1
- 3
Some problems occured in AM335x with SX1301
#130 opened by suyiii - 1
Gateway Power consumption
#144 opened by EoinBullock - 2
SX1301 Calibration Test
#142 opened by sgodey - 1
Warning: 80 not a valid if_chain number
#140 opened by EoinBullock - 1
How i get Phase of singal?
#139 opened by solomy - 10
Can this code receive non Lorawan packets?
#137 opened by EoinBullock - 1
FSK Settings
#136 opened by EoinBullock - 1
- 1
- 2
- 1
stm32mp1 host: util_spi_stress -t 4 failed
#160 opened by vrepetenko - 0
- 0
How to install using wget?
#147 opened by zedisc - 2
- 0
How i get Phase information ?
#138 opened by solomy - 4
util_spi_stress.c -t 4
#131 opened by pandaxiao22