MaslowCNC/GroundControl
This is the Ground Control software used to control the Maslow CNC Machine
PythonGPL-3.0
Issues
- 10
Enhancement: Return to 12 o'clock
#709 opened - 3
- 1
- 5
- 11
- 1
- 2
Calibration issues on Raspberry Pi 3
#696 opened - 6
- 6
1 Deg CCW button does not move motor
#693 opened - 1
CCW .1 moves CW in tooth alignment interface
#692 opened - 1
- 9
- 4
- 9
gcodeCanvas.py reloadGcode() converts parameters to e-notation, causes incorrect operation
#676 opened - 5
- 4
Need button to ignore 38.2 probe GCODE
#670 opened - 7
GroundControl Error message
#668 opened - 3
- 6
Unable to find position when calibrating
#659 opened - 1
Feature Request: Last successful line read
#657 opened - 5
Red & Green start & stop circles
#656 opened - 5
- 0
- 31
- 6
- 2
.jpg vs .JPG (Linux issue)
#646 opened - 2
- 3
GC assumes it can reset the target board.
#638 opened - 0
A way to make weird things happen with the g-code - is there a bug in the g-code offsetting code?
#637 opened - 10
- 8
Limit the Z Axis travel of the G38.2 code
#632 opened - 2
Set z-axis 'safe travel' in Settings page
#629 opened - 3
- 2
Division by zero in speed calculation
#625 opened - 2
- 2
- 2
- 1
- 2
- 10
Ground Control runs, but renders incorrectly
#614 opened - 1
- 8
- 2
- 3
Add an Abort to calibration sequence
#597 opened - 4
- 3
After Z cal, move to safe height
#595 opened - 9
- 6
Reorder calibration screens
#593 opened - 5
- 35