beagleboard/beaglebone-blue

BeagleBone Blue doesn't save config

Closed this issue · 3 comments

BluePackStack commented

I am not sure whether I am allowed to ask this question here, but any help is pretty much appreciated. I tried to change the wifi config.
connmanctl> tether wifi disable ...
But no effect . What can I do?

  • currently running/booting Debian 9.2 2017-10-10 4GB SD IoT from sd card
  • already pluged in 12Vdc adapter to improve power-same result
  • tried to shutdown -r now
  • and replaced the image on sd card with this one: Debian 9.1 2017-09-21 4GB SD IoT image

Hope someone can help. :(

RobertCNelson commented

@BluePackStack all the out of box control of wl18xx for the default image is located in:

/etc/default/bb-wl18xx

Regards,

  • ❤️1
RobertCNelson commented

It's not buggy, just highly intergrated for the out of box experience... I've setup /etc/default/bb-wl18xx so you can disable parts of it..

BluePackStack commented

It's not buggy, just highly intergrated for the out of box experience... I've setup /etc/default/bb-wl18xx so you can disable parts of it..<

I cleared my early response and went to bed then, since I recognized, that the board wouldn't response to ssh anymore after editing the settings.

I inserted/eddited one single 'no' since I do not need softap/tether at the moment:

TETHER_ENABLED=no

System then crashes. However, just changing PW and SSID works fine now.

And updates after rebooting only.

Using: bone-debian-9.2-iot-armhf-2017-10-10-4

I am very happy that you helped me! Thanks for helping!!!!