/Red_Tracker

Uses the D8M camera module, then processes the image to detect red objects, and then overlay an x,y crosshair on the largest red object. See the video. Pure Verilog. (No soft-core processor.)

Primary LanguageVerilog

Red_Tracker

This project interfaces with a D8M camera module by Terasic. It detects any red object, and tracks it.

Demo_video

image

The incoming camera video (at 60 fps) is filtered for red pixels and creates a frame buffer. This red-pixel frame buffer is shown on the MP4 video file.

It then finds the center of the largest red mass, and overlays a crosshair on it.

This project uses the Cyclone IV FPGA used in the DE2-115 evaluation board to:

a) configure and interface to the camera module

b) buffer the raw video into an SDRAM frame buffer

c) simultaneously, detect red pixels and create a second frame buffer

d) while doing this, also low-pass filters that video,

e) and also while creating/filtering the second frame buffer, detect the largest red mass

f) generate the x,y coordinate of the center of the red mass

g) overlay a crosshair onto the video going to the VGA output

h) FPGA also has a VGA frame buffer and creates the VGA waveform

*** Possible Improvements ***

  1. Could create a PWM signal to drive servo motors to move the camera to track the red object.

  2. Fire a nerf cannon at the red object.