Stepper motor problem
eteache opened this issue · 3 comments
eteache commented
Hi,
I've assembled everything, but the motor doesn't turn. What checks can I do?
Is it normal for the motor driver to get so hot even with the heat sink?
function3d commented
Hi, you probably have a short circuit, check the adjoining welds that are
not communicating.
El sáb, 3 jun 2023 a las 1:30, eteache ***@***.***>)
escribió:
… Hi,
I've assembled everything, but the motor doesn't turn. What checks can I
do?
Is it normal for the motor driver to get so hot even with the heat sink?
—
Reply to this email directly, view it on GitHub
<#43>, or unsubscribe
<https://github.com/notifications/unsubscribe-auth/A2GTVH4FG4FL52C4MRQPV6LXJJZSDANCNFSM6AAAAAAYY4VCMM>
.
You are receiving this because you are subscribed to this thread.Message
ID: ***@***.***>
scalinux commented
Try testing the motor without drive using this as example. Also check youtube videos explain how to. Good luck!
eteache commented
Motor is fine, tried to connect directly to my 3D printer and works fine. After two boards built, I think I'm welding bad some component...