jpconstantineau/ErgoTravel

Issues

• Some questions about ErgoTravelLight 3.01

  #36 opened 2 years ago by Ardakilic
  9

• Serial implementation

  #28 opened 3 years ago by Derecho
  2

• V1.03 gerber not recognised by JLCPB

  #35 opened 3 years ago by Daveyr
  14

• PCB Choc tested?

  #29 opened 3 years ago by Cwejman
  12

• Acrylic Case Path Lengths and Thickness

  #33 opened 6 years ago by sedgwickc
  7

• Question: Partially assembled ErgoTravel ProMicro attachment

  #32 opened 6 years ago by berfarah
  2

• Holes for PCB mounted switches are too tight

  #14 opened 6 years ago by ckofy
  4

• Move ErgoTravel to use split_common library (QMK)

  #27 opened 6 years ago by SethBarberee
  3

• Complete build guide

  #10 opened 6 years ago by jpconstantineau
  0

• Complete ordering guide

  #11 opened 6 years ago by jpconstantineau
  4

• What type/brand socket allow for 12mm standoffs

  #8 opened 6 years ago by jpconstantineau
  2

• Top Plate: Add Location where PCB Fab shops can write their Job ID

  #5 opened 6 years ago by jpconstantineau
  3

• V1.01 Silkscreen extra lines

  #23 opened 7 years ago by jpconstantineau
  1

• Can I2C support Underglow RGB?

  #7 opened 7 years ago by jpconstantineau
  1

• Label TRRS connector Signals

  #18 opened 7 years ago by jpconstantineau
  1

• Is top plate good with plate mount switches

  #13 opened 7 years ago by jpconstantineau
  2

• Swap SCL/SDA as the Extra Data Line (As per all other Split builds...)

  #21 opened 7 years ago by jpconstantineau
  1

• Holes for diodes could be slightly larger

  #16 opened 7 years ago by viet-pham
  0

• Move diode D13 outside of the area where the pro micro will be installed

  #15 opened 7 years ago by viet-pham
  1

• Create FAQ

  #9 opened 7 years ago by jpconstantineau
  1

• Create 3D printed case using openscad

  #12 opened 7 years ago by jpconstantineau
  0

• Some lines bends are square and not 45 degrees

  #2 opened 7 years ago by jpconstantineau
  1

• VCC Power Lines are too thin

  #1 opened 7 years ago by jpconstantineau
  1

• Add Labels to WS2812 header

  #6 opened 7 years ago by jpconstantineau
  1

• Switch Labels are not numbered

  #3 opened 7 years ago by jpconstantineau
  1

• Standoff screw holes are labelled but should not

  #4 opened 7 years ago by jpconstantineau
  1