/probe_basic

User interface for the LinuxCNC machine control.

Primary LanguagePythonGNU General Public License v3.0GPL-3.0

Documentation

installation

https://kcjengr.github.io/probe_basic/quick_start.html

Development installation

https://kcjengr.github.io/probe_basic/dev_install.html

QtPyVCP use documentation

https://qtpyvcp.com

Development

Documentation and Help

Dependencies

Probe Basic is developed and tested using the LinuxCNC Debian 12 x64 (bookworm) Install ISO. It should run on any system that can have PyQt5 installed, but Debian 12 x64 is the only OS that is officially supported.

DISCLAIMER

THE AUTHORS OF THIS SOFTWARE ACCEPT ABSOLUTELY NO LIABILITY FOR ANY HARM OR LOSS RESULTING FROM ITS USE. IT IS EXTREMELY UNWISE TO RELY ON SOFTWARE ALONE FOR SAFETY. Any machinery capable of harming persons must have provisions for completely removing power from all motors, etc, before persons enter any danger area. All machinery must be designed to comply with local and national safety codes, and the authors of this software can not, and do not, take any responsibility for such compliance.

This software is released under the GPLv2.