MKS tinybee board

Question

MKS tinybee board

ahmedhassan3298 opened this issue a year ago · 3 comments

ahmedhassan3298 commented a year ago

Hi all,
my MKS tinybee board give error in temperature when i connect end stop for y-axis

Answer 1 · 2023-05-03T06:43:48.000Z

#36
Check this, maybe it helps you. Try using only 2 pins for the endstops

Answer 2 · 2023-05-03T10:20:55.000Z

Thanks for your help
I Try 2 pins (S,G) for the end stop The end stop dont stop the motor

Answer 3 · 2023-05-03T12:51:55.000Z

Is it tied NC (normally closed) the switch? If the switch has 3 pins u should tie the two from each side and leave the middle pin unconnected. Also make sure it is in the right axis slot, x, y, z