please help , the board does not show up on Arduino/Cura.
paulc1218 opened this issue · 1 comments
paulc1218 commented
Hi printers ;)
i have just received a printer which uses the MKS gen L , when i was trying to upgrade the firmware to marlin, my computer doesnt seems to recognise the printer , nothing is showing up on the Arduino ide nor on any slicers i use.
i have tried :
- using different cables,
- download 340 driver (not sure if i am using the right one)
- try to connect to a different printer (which works)
- disconnecting the TFT
am i missing something here ? any advise is appreciated.
thanks in advance
makerbase-mks commented
Hi!
- CH340 driver https://raw.githubusercontent.com/makerbase-mks/Software/master/CH340G_USB%20Driver/CH340G_USB%E9%A9%B1%E5%8A%A8.rar
- You need check you port and Baud rate is the same