nliaudat/esp32_8ch_motor_shield

Issues

• Need help

  #56 opened 6 months ago by rzerres
  7

• BEMF is NOT working

  #46 opened 8 months ago by heinemannj
  43

• [BUG] - short circuit at BMEF in Bord: v57 rev 1.48

  #55 opened 9 months ago by DerMo92
  1

• [FEATURE REQUEST] add temp. sensor for VL and RL per channel for doing thermal balancing?

  #4 opened 9 months ago by linuxdep
  13

• Need help - Order Error jlcpcb.com

  #50 opened 9 months ago by grericht
  4

• Documentation: Usage of 1-wire temperature sensors

  #45 opened a year ago by heinemannj
  1

• Documentation: Difference between Floor heating and Motor control firmware

  #44 opened a year ago by heinemannj
  1

• Documentation: Add dimensions of the board and the box

  #43 opened a year ago by heinemannj
  1

• [BUG] closed source project on github?

  #35 opened 2 years ago by QuadCorei8085
  5

• [FEATURE REQUEST] DC version

  #34 opened 2 years ago by WMP
  1

• [BUG] USB and DC power supply separation by diode

  #30 opened 2 years ago by WMP
  3

• Need help

  #32 opened 2 years ago by uplight-dev
  8

• Unable to read BEMF

  #9 opened 3 years ago by nstadigs
  36

• [BUG] CH6 input shorted to CH7/8 BEMF

  #27 opened 2 years ago by microtronics
  1

• [FEATURE REQUEST] Create new board to connect DHTxx or DS18B20 thermometers.

  #24 opened 2 years ago by WMP
  1

• SCREW_HOLE_GROUD

  #23 opened 2 years ago by WMP
  2

• Not an issue: I will have 6 assembled boards available for german buyers...

  #12 opened 2 years ago by Lonestar78
  9

• H1 H3 cannot match the corresponding pads on the PCB board

  #11 opened 2 years ago by flexmatics
  2

• Order possibilities ?

  #10 opened 3 years ago by marcelveldt
  11

• In the latest version + and - are connected

  #8 opened 3 years ago by nstadigs
  7

• [FEATURE REQUEST] Use an external power adapter?

  #7 opened 3 years ago by nstadigs
  5

• Move the rj11 connectors a little bit over the edge of the board

  #5 opened 3 years ago by nstadigs
  4

• ESP hangs and L9110S gets very warm

  #6 opened 3 years ago by nstadigs
  13

• Could you push your EDA Files

  #1 opened 4 years ago by melad
  3

• EasyEDA Project source

  #3 opened 3 years ago by rubenmuehlhans
  2

• Request for clarification

  #2 opened 4 years ago by nstadigs
  4