pachterlab/poseidon
poseidon system - open source syringe pumps and microscope for laboratories
Jupyter NotebookBSD-2-Clause
Issues
- 1
- 3
Commands are not reflected in motor movement
#37 opened by gallagherk17 - 1
Arduino code issues
#39 opened by jsdearbo - 4
The commands were not sent to stepper motors; however, the board connected to the gui controller successfully
#33 opened by maydanshahi - 0
Error compiling for board Arduino Uno
#40 opened by ymorayko - 1
No module named PyQt5 -- raspbian
#38 opened by gamselem - 1
Settings never finish sending
#36 opened by gallagherk17 - 1
Linear Bearings won't fit into their slots
#35 opened by gallagherk17 - 0
Add time control
#32 opened by MariaVeronica92 - 2
- 1
Arduino Serial COM doesnt work
#27 opened - 1
Python ord() expected a character error
#28 opened - 0
Resizing GUI when camera is enabled on RPi
#26 opened by 5Aki1 - 0
Add comment for units of Syringe Areas
#25 opened by virajshah - 0
- 1
Need documentation on how to use the software
#11 opened by Xqua - 1
Low flow rate error
#20 opened by Munfred - 0
Adding name text field to pumps
#21 opened by Munfred - 10
Recoding the arduino code
#14 opened by Xqua - 3
GUI number not updating
#12 opened by Xqua - 9
Steppers are not independant !
#10 opened by Xqua - 1
Stop button does not work on GUI
#7 opened by Munfred - 0
Absolute button does not work on GUI
#8 opened by Munfred - 0
Add `apply to all` button for updating speeds/directions on all syringes at once
#3 opened by Munfred - 1
Add a max speed warning and cap
#4 opened by Munfred - 0
Camera only active when running on RPi
#5 opened by Munfred - 0
Add flow rate gradient functionality
#6 opened by Munfred