voron-trident-vt.xxx-klipper-backup

Automated backup of klipper config

Voron Trident 300mm (unserialed)

Mainly using fluidd

discord: quok#1849

About This Printer

Voron Trident built February 2022 from a Fabreeko kit, with some changes and extra mods.

The printer is using a Fysetc Spider 2.2 MCU and TMC 2209 stepper drivers. I have 5160HVs on the way for the A/B (X/Y) steppers and will go 48V at that time. I'm not using the LDO V1/V2 motor kit that was included; instead I am using LDO 42STH48-2504AH steppers. These are the same steppers used in the RatRig vCore 3 I believe. They are 2.5A high temp steppers that should work great with the 5160HVs I have on the way.

This printer makes use of a number of mods, as listed below.

Mods

Stealthburner w/ Clockwork 2 Extruder
Titanium Extrusion Backers
Klicky Probe
Nozzle Scrubber
Polysulfone Bed Standoffs
Microswitch Endstop PCB
Sexbolt Z Endstop
Pins Mod
Sturdy Handles
Rama'sFront Idlers
WLED controlled RGB case lighting using new moonraker wled component running on a separate ESP32

Other Misc Features

Git backup - using SSH authentication
lcd_tweaks.cfg
gcode_shell_command klipper extension - allows you to use a gcode macro to run shell commands. I use this to trigger automatic git backups to this repo.

Links

Voron User Mods
https://vorondesign.com/

Klipper

Ellis' PIF Profile
Ellis' Print Tuning Guide

Other klipper backups I've found useful

https://github.com/richardjm/voronpi-klipper-backup https://github.com/AndrewEllis93/v2.247_backup_klipper_config
https://github.com/pushc6/VoronConfig
https://github.com/kageurufu/3dp-voron2/tree/master/printer
https://github.com/wile-e1/klipper_config
https://github.com/th33xitus/klipper_config