Issues
- 0
- 0
access both i2c on minibreakout
#58 opened by farfromrefug - 14
- 2
- 10
Trouble getting motor control to work with Pololu DRV8835 Arduino motor shield
#34 opened by vrubiolo - 4
PingFirmata on the Edison
#55 opened by WoodyWoodsta - 0
- 14
Pin name undefined? (Issues regarding a fork)
#52 opened by virgilvox - 0
Serial support
#50 opened by dtex - 0
- 12
[question] Any chance of supporting debian?
#38 opened by Awk34 - 23
Johnny five + Intel Edison + BMP180
#47 opened by teuteuguy - 8
galileo-io is maxing out the CPU
#18 opened by adampasz - 0
One Wire support
#46 opened by rwaldron - 0
Use sample rate for i2c read interval
#45 opened by rwaldron - 8
Servo on DFRobot Edison shield
#44 opened by Legendaire - 9
Edison Mini Board has no connection at pin A
#43 opened by Legendaire - 1
Installing johnny-five, galileo-io
#42 opened by freshfruit - 3
- 4
install failure with status 255
#36 opened by jzheng-stoneriver - 6
- 2
Device or Firmware Error
#33 opened by rubenmp8 - 10
Steppers not supported?
#29 opened by rubenmp8 - 10
Beginner Feedback
#14 opened by garrows - 6
trouble to install galileo-IO
#31 opened by alperpelik - 10
Issue creating a new sensor on pin A0
#28 opened by scazan - 3
Issue w/ setSamplingInterval in J5, galileo-io, node-red and node-red-contrib-gpio setup
#30 opened by Jbossalini - 0
Implement setSamplingInterval
#19 opened by rwaldron - 0
new Pin.IO.Gpio(1, undefined); avoid seg fault
#26 opened by rwaldron - 14
- 26
- 4
- 5
Possible Issue with I2C?
#22 opened by ashishdatta - 0
- 13
new io.Gpio(this.addr) fails
#20 opened by andrewfaria - 6
analogRead throws error on Gen 2
#17 opened by ryoshu - 80
Digital write not working on PWM pins, Gen 2
#16 opened by ryoshu - 0
- 0
Keep file descriptors open
#2 opened by rwaldron - 0
Replace open + writeFile with appendFile
#11 opened by rwaldron - 1
fs: missing callback Error: ENODEV, write
#13 opened by qwertypants - 7
"exit" process isn't triggered
#12 opened by qwertypants - 0
- 3
- 3
digital gpios niot getting initialised
#7 opened by gilesbradshaw - 12
Getting started requirements
#10 opened by glued - 3
analogWrite giving strange values
#8 opened by cyamada - 1
- 10
fs: missing callback Error
#3 opened by luigif - 1
Wrong unexport path
#4 opened by luigif