Issues
- 2
Show thumbnail from gcode when printing?
#69 opened by matphillips - 0
- 7
- 0
git clone fail on windows
#66 opened by thghca - 1
Shutting down Raspberry from display
#64 opened by niklasb22 - 0
- 1
Add support for moonraker update_manager
#58 opened by besanur - 0
Target Temperature and X/Y/Z Position Data Fields Are Not Zeroed After an Emergency Stop & FW Restart
#57 opened by Thinkersbluff - 2
Cancel macro wäre ein anderes
#47 opened by Robnex - 1
- 2
Verbesserung screensavers
#49 opened by Robnex - 0
install_for_mainsailos.sh prints out "Display will be available in arround 15 seconds" also when configuration has failed.
#52 opened by seho85 - 0
Check version of python-dgus library at run time
#26 opened by seho85 - 0
Create a "support help script" that collects info about the current installation and the setup that can be for support
#55 opened by seho85 - 1
Wrong IP in websocket.json
#54 opened by Robnex - 2
Verbesserung: Hinweis auf homing bei ztilt
#48 opened by Robnex - 11
Gcode user macro 2 funktioniert nicht
#46 opened by Robnex - 3
Use Vyper mainboard serial port instead of Pi's
#53 opened by daduke - 2
Axes/Position 1mm Step
#45 opened by SamNitro - 1
Start print of GCode file to print from Display
#50 opened by Robnex - 0
Background light dimming
#42 opened by seho85 - 0
Extrude and Retract Button using M82 (Extruder Absolute Postion) instead of M83 (Rel. Position), that causes that retract and extrude can be not performed multiple times.
#41 opened by seho85 - 0
- 0
- 0
Add Pause/Cancel and Stop to Overview Mask
#25 opened by seho85 - 0
Add Button for Z-Tilt to Axes Mask
#28 opened by seho85 - 0
- 1
- 1
Created start script
#20 opened by Robnex - 1
Create stop script
#21 opened by Robnex - 1
Create install script
#22 opened by Robnex - 2
Create systemd service file to enable automatic startup of display control application
#18 opened by seho85 - 0
- 0
Enable user to set config directory
#23 opened by seho85 - 0
- 0
Use python logging instead of print(..)
#17 opened by seho85 - 0
Emergency Stop not working on all masks
#13 opened by seho85 - 0
Back buttons missing on multiple masks
#12 opened by seho85 - 0
printer ip and port from websockt.json not used
#10 opened by seho85 - 0
- 1
fan_display_mask.py: Figure out why thread is not ended properly and remove workarround (timeout in synchronous display read/write functions)
#3 opened by seho85 - 0
tuning_mask.py: Figure out why thread is not ended properly and remove workarround (timeout in synchronous display read/write functions)
#2 opened by seho85 - 0