Introduction
This project aims to build a low cost, highly customizable yet large volume 3D printer that use standard hardware components combined with a few custom printed components. It is an all leadscrew construction and runs on Marlin firmware.
Components
- Aluminum T slot profile and supporting components( die cast plugs, two way joint, t-nuts)
- Trapezoidal leadscrews(8mm)
- Smooth rods (8mm)
- NEMA 17 stepper motors and stand
- E3D V6 set with PTFE tube, bowden extruder, PLA filament
- Heatbed
- Arduino MEGA, Polulo RAMPS, A4988 stepper drivers
- Power supply(12V/20A)