Video Stabilization

This repo is to implementation video stabilization by gyroscope, which is based on paper A Non-Linear Filter for Gyroscope-Based Video Stabilization

You can refer the algo memo: https://github.com/lesialin/video_stab/blob/main/doc/algo_memo/Non_Linear_Filter_of_vid_stab/Non-Linear%20Filter%20for%20Video%20Stabilization.md

The simulation of vid_stab flow is as below,

configuration

The configuration in config/ folder, include:

debug_config.json

test_mode: in test_mode you can test log in test_frame_no
start_frame_no: run the video start from start_frame_no
preserve_margin: crop the outer margin or not
log_image: log result comparison frame

{
    "eis_pass1": true,
    "eis_pass2":false,
    "rs_correct_off": false,
    "test_mode":false,
    "test_frame_no": 100,
    "start_frame_no":0,
    "preserve_margin":false,
    "log_image":true   
    
  }

eis_config.json

crop_ratio: crop ratio, ex 0.1 means crop 10% height/width each side
alpha: low-pass filter coefficient, if use constant filter
alpha_min: the minimum low-pass filter coefficient, if use non-linear filter
alpha_max: the maximum low-pass filter coefficient, if use non-linear filter
beta: the low-pass filter response coefficient
gamma: the low-pass filter coefficient for the lookahead frame motion
inner_padding_ratio: the inner padding ratio of crop region
lookhead_no: the lookahead frame number
knee_point: knee point number for image warp
use_nonlinear_filter:use non-linear filter or not

{
    "crop_ratio": 0.1,
    "alpha": 0.9,
    "alpha_min": 0.75,
    "alpha_max": 0.95,
    "beta": 1.0,
    "gamma": 0.9,
    "damping": 0.95,
    "inner_padding_ratio": 0.0,
    "lookahead_no": 10,
    "knee_point": 39,
    "use_nonlinear_filter": true
  }

gyro_sensor_config.json

{
    "gyro_bias": [
        2.68081035e-04,
        -5.34824714e-04,
        -9.35238864e-05
    ],
    "sample_rate": 460
}

coord_trans_matrix.json

{
    "coordinate_trans_matrix":[
        [1,0,0],
        [0,1,0],
        [0,0,1]
    ]
}

video_config.json

{
    "preview_height": 720,
    "preview_width": 1280
}

cmos_sensor_config.json

blanking: the blanking number of the cmos frame

{
    "blanking": 68,
    "cmos_frame_height": 3000,
    "cmos_frame_width": 4000,
    "effective_height": 2256,
    "effective_width": 4000,
    "focal_in_mm": 4.74,
    "sensor_width_in_mm": 6.4
}

siggen_config.json

gyro_log_idx: the order in gyro log
gyro_time_scale_exp: the timestamp scale in exp
cmos_time_scale_exp: the timestamp scale in exp

{
    "gyro_log_idx": [0,1,2,3],
    "gyro_time_scale_exp": 7,
    "cmos_time_scale_exp": 7
    
}

youruncleda/video_stab

Video Stabilization

configuration