Issues
- 0
Feature Request: Jinja Config 'Variables'
#342 opened by lraithel15133 - 2
- 0
- 2
- 1
- 3
- 3
- 2
- 0
Feature Request: add pre/post-attach and pre/post-detach gcode options to dockable_probe
#327 opened by lraithel15133 - 4
Dockable probe errors when used with safe_z_home
#322 opened by ressu - 0
Clock PLL configuration bugs
#323 opened by calithameridi - 2
heater_fan shutdown speed
#290 opened by Gethe - 1
- 2
Add accels_per_hz as a parameter to `TEST_RESONANCES`
#295 opened by rogerlz - 1
Second extruder motor not spinning when it should on dual extrusion prints
#292 opened by OldGuyMeltsPlastic - 0
M26 does not work at start of print
#302 opened by richfelker - 3
[Question] Possible to heat one element with two heaters and two thermistors?
#294 opened by RoboticKoala - 2
- 0
- 0
Z_TILT_AUTODETECT crashes with an error
#232 opened by kingnoob1377 - 3
Feature Request: Native support for heated part cooling control (fan+heater+temp sensor)
#198 opened by levins-law - 4
PA smoothing of base position is unmotivated and has multiple negative consequences
#207 opened by richfelker - 2
- 1
feature request: change example start_pa_test macro to allow of finer pa tuning
#238 opened by Jakob-Eichberger - 1
- 1
- 1
Feature Request: mesh best fit tilt
#214 opened by lukeslaboratory - 0
Possible Bug: DS18B20 and MCU timeouts
#217 opened by rogerlz - 2
Lack of information and where to find it?
#215 opened by TheVoronModder - 1
Regressions in firmware retract
#204 opened by richfelker - 0
Feature Request: Minimum fan spool-up time
#195 opened by ganzgustav22 - 1
Feature request: Fan mixer
#168 opened by ogland - 3
- 1
Feature Request: Tell me what sensor Klipper got its knickers in a bunch about
#161 opened by lukeslaboratory - 1
Feature Request: Add idle_timeout 0 selection
#163 opened by Kizime123 - 1
Remove Danger Klipper Guide
#166 opened by Remorpher - 2
Fix SAVE_CONFIG to apply to imported .cfgs
#149 opened by lraithel15133 - 1
Happy hare throws error with DK
#137 opened by reapola - 3
- 3
- 2
- 1
- 1
Feature Request: Allow controller_fan To Accept temperature_fan as 'heater' Argument
#116 opened by lraithel15133 - 1
- 1
Feature Request: danger_options flag to enable and disable gcode shell execution
#131 opened by TheRealDeathsneeze - 5
- 7
Feature request: Expand Klipper make menuconfig options to disable optional/unneeded features
#126 opened by VinnyCordeiro - 3
Feature request: add danger options flag to ignore min/max temps for thermistors
#114 opened by TheRealDeathsneeze - 1
Feature Request: Additional Parameter - inital_horizontal_move_z for gantry leveling
#123 opened by AlbinoDeer - 0