Issues
- 1
Btt-skrat-10 config.cfg
#147 opened by Travis90x - 1
Configuring VC3 with Beacon probe should automatically override the Z-Tilt positions to be correct
#262 opened by galile0-designs - 1
BTT Manta M8P v2 - Wrong SPI Pinout
#268 opened by aardvarkglory - 1
Prusa MK3S generated configuration errors
#272 opened by david-antos - 3
- 3
- 1
MAX31865 Option
#263 opened by aardvarkglory - 25
Manta M8P V2.0
#157 opened by trudeau87 - 2
4p fan configs point to the same pin
#189 opened by jhorn70 - 1
Configuration wizard
#190 opened by IridianZore - 1
additional inpout shper config for Minion template
#124 opened by HelgeKeck - 2
Error executing manual mesh with Euclid probe, using profile name with a space
#126 opened by etotheipi - 1
- 1
Duplicate configure screen entries for SKR 3 EZ
#164 opened by LongLiveCHIEF - 1
typo in vcore3 template
#154 opened by jscancella - 4
Slow UI load times
#144 opened by jLynx - 1
- 0
Automatic probe offset and Probe for priming
#142 opened by mcr83 - 0
btt-skr-mini-e3-30 config
#143 opened by igor72ita - 1
Missmatch with SKR Mini E3 V3
#111 opened by McNik1997 - 1
- 0
GSTAT error- hotend cooling while resting
#103 opened by ptegler - 3
ADXL345 axis mapping
#102 opened by GP3D84 - 12
homing_override 'middle'
#98 opened by JiMcNulty - 2
- 1
Dangerous behaviour with stowable Probes when having a fault while Homing
#97 opened by Heisenberg19x - 0
Configurator - Update Verbage for Instructions
#96 opened by 8Complex - 1
- 1
BTT Manta M8P stops booting when using SPI drivers and ADXL345 at the same time.
#94 opened by miklschmidt - 2
Typo in macros.cfg?? Should it be M400e or M400??
#67 opened by smackoz - 2
- 1
M91 in combination with restoring the state after the PRIME causes the XY to run in relative mode
#89 opened by 8Complex - 2
Toolboard adxl naming conflict with mainboard.
#79 opened by Spotigus - 5
[FR] Allow Z park configurations
#40 opened by psiberfunk - 0
- 2
Issue with Sensorless Homing on new config
#55 opened by Anon0ne - 3
- 1
Make the RatOS macros handle V Core 3 enclosure
#38 opened by rkaronde - 3
Change Homing Behavior For GENERATE_SHAPER_GRAPHS
#53 opened by brenond - 1
Compile Firmware Permission denied
#41 opened by hliebscher - 2
FR: Proper newline at the end of any cfg file
#42 opened by kmarty - 0
- 2
- 1
klipper-mcu-update.sh & (any) make-and-flash-mcu.sh has root/non-root requirement collision
#29 opened by kmarty - 5
Thoughts for the END_PRINT macro
#21 opened by LucidityCrash - 3
- 0
[FR] When heating up for ABS etc, rotate the parts fan slowly to support convection
#12 opened by top-gun