RoboJackets/robonav-electrical

Issues

• estop radios are permanently reset

  #43 opened 4 years ago by etillison3350
  1

• estop_tx board 3.3v pwr doesn't work

  #41 opened 4 years ago by Cryptum169
  1

• PID should be able to self-tune

  #22 opened 4 years ago by Cryptum169
  3

• Tracking eagle libraries merge conflicts

  #54 opened 4 years ago by Cryptum169
  3

• Remove firmware from repo

  #40 opened 4 years ago by oswinso
  0

• Remove current branches

  #35 opened 4 years ago by Cryptum169
  1

• estop_rx board has 24v going into microcontroller

  #42 opened 4 years ago by Cryptum169
  2

• Auto-reenable of estop system when Disengage button pulled out too fast.

  #44 opened 5 years ago by Cryptum169
  1

• Remove mbed code from repo

  #32 opened 5 years ago by oswinso
  2

• Restructure master file branch structure

  #36 opened 5 years ago by Cryptum169
  0

• Pid should only be run when not estopped

  #29 opened 5 years ago by oswinso
  2

• Determine Monitor Power Requirements

  #6 opened 5 years ago by barulicm
  1

• Documentation

  #5 opened 5 years ago by barulicm
  0

• Switch Between OSMCs and Motors

  #4 opened 5 years ago by barulicm
  0

• Laptop Dropping Out

  #3 opened 5 years ago by barulicm
  3

• Power indicator on Motor Board V2

  #2 opened 5 years ago by barulicm
  0

• Pot for controlling headlight brightness

  #1 opened 5 years ago by barulicm
  0

• NUC Ethernet connection setup

  #24 opened 6 years ago by Cryptum169
  1

• MBED should accept speeds at any resolution

  #20 opened 6 years ago by JasonGibson274
  2