VC-MIPI-modules/vc_mipi_nvidia

Issues

• Support for L4T 36.2 on Orin NX / Orin Nano Devkit

  #120 opened 3 months ago by pmliquify
  0

• Error on porting vc_mipi_nvidia module to orin nano

  #119 opened 4 months ago by lipingioiopeter
  0

• Add third party vc mipi nvidia module, how to add porting?

  #118 opened 4 months ago by lipingioiopeter
  0

• How does orin nano port vc mipi nvida

  #117 opened 4 months ago by lipingioiopeter
  0

• IMX264 sensor not accepting colors correctly.

  #116 opened 4 months ago by hseysen
  1

• Support for L4T 32.7.5

  #115 opened 4 months ago by pmliquify
  0

• IMX264 Camera Not Detected After Following Setup Steps on Ubuntu 18.04 with L4T 32.7.1

  #114 opened 4 months ago by Sadegh-Kalami
  3

• Configuration VC_MIPI_CAM_0=0 and VC_MIPI_CAM_1=1

  #112 opened 5 months ago by fre-wolf
  2

• Any support for R36.3.0 ?

  #113 opened 5 months ago by noob502
  1

• Improve documentation: Without correct meta data high there is not timestamp

  #107 opened 6 months ago by pmliquify
  0

• ROI width alignment different for v4l2 and GStreamer => improve documentation

  #106 opened 6 months ago by pmliquify
  1

• Support for L4T 35.5.0

  #109 opened 5 months ago by pmliquify
  1

• Patch issue

  #108 opened 5 months ago by bratiranjan11
  4

• Issues with the nvarguscamerasrc and v4l2 pipeline

  #110 opened 5 months ago by narbada18
  0

• Support for L4T 36.3

  #97 opened 7 months ago by bazo80
  0

• Any plans for Jetson AGX Orin support?

  #95 opened 7 months ago by justinblaber
  1

• L4T 36 issues with IMX568 and IMX566

  #103 opened 6 months ago by kkhakixyz
  2

• 0.17.1 TX2NX, JNX30D still imx219 is active

  #100 opened 6 months ago by pmliquify
  0

• Error in setting up nvidia-l4t-gputools for L4T 32.7.3

  #104 opened 6 months ago by pmliquify
  0

• Error description in case of wrong binning/roi combinations

  #105 opened 6 months ago by pmliquify
  0

• Check resolution alignments for all cameras, platforms and bsps

  #92 opened 7 months ago by pmliquify
  0

• Frame rate increase for binning modes

  #98 opened 7 months ago by bazo80
  0

• 0.17.1, Jetson Nano with IMX415: Multi-bit transmission error

  #99 opened 6 months ago by pmliquify
  0

• ./setup.sh --target => set standard IP to nvidia and RSA to id_rsa

  #101 opened 6 months ago by pmliquify
  0

• Documentation for frame_rate

  #87 opened 7 months ago by pmliquify
  0

• Refactoring of function vc_sen_set_roi

  #102 opened 6 months ago by pmliquify
  0

• VC Driver reports Error -34 on boot

  #96 opened 6 months ago by s-withers-archangel
  2

• JN30A 38346-3 sensor_common_parse_image_props:active_l propperty missing / Failed to read mode 0 / Failed to initialise imx219

  #89 opened 7 months ago by Frennz
  10

• Patch failled for L4T 35.3.1

  #88 opened 7 months ago by noob502
  9

• IMX412 flashes bright and dark in low light

  #90 opened 7 months ago by sb3d-tech-mteitel
  1

• "demo.sh --argus" does not work

  #94 opened 7 months ago by VC-Support
  0

• MIPI bus lane speed for IMX250/Xavier NX

  #91 opened 7 months ago by taldhous-imetrum
  0

• VC Driver installation is always failing For Jetson Nano 4G B01 Board

  #86 opened 7 months ago by Frennz
  7

• With the Orin Nano and 2 IMX568 cameras, there is tearing in the image.

  #67 opened 10 months ago by burak-ayd
  2

• Do I need to change dtsi for Camera Triggering

  #75 opened 10 months ago by musafzenbilci
  2

• error: ‘tRet’ may be used uninitialized in this function [-Werror=maybe-uninitialized]

  #83 opened 9 months ago by RoyAmoyal
  2

• Device tree configuration for Jetson Linux 36.2

  #73 opened 10 months ago by andresmanelli
  1

• error: make: *** [Makefile:213: __sub-make] Error 2

  #85 opened 8 months ago by ardadi
  1

• Flash Xavier NX on Jetson Nano Developer Kit carrier board

  #84 opened 9 months ago by hideyourbugs
  0

• Support for L4T 35.5.0

  #81 opened 9 months ago by flixr
  0

• Support IMX900

  #79 opened 9 months ago by pmliquify
  0

• Remove support for NVIDIA L4T 32.3 - 32.6

  #78 opened 9 months ago by pmliquify
  0

• Support embedded metadata for IMX296 and other cameras

  #70 opened 10 months ago by pmliquify
  0

• Support NVIDIA L4T 35.4.1

  #71 opened 10 months ago by pmliquify
  0

• Support NVIDIA L4T 36.2

  #77 opened 9 months ago by pmliquify
  0

• XavierNX with IMX183 version above 0.12.3

  #72 opened 10 months ago by PierrickIntom
  5

• Problem porting from Yocto Dunfell to Kirkstone - Cameras detected but no video devices created.

  #74 opened 9 months ago by taldhous-imetrum
  1

• nvarguscamerasrc fails

  #66 opened 10 months ago by nirushka
  5

• Fixed stability issue with nvarguscamerasrc

  #69 opened 10 months ago by pmliquify
  0

• NVIDIA Jetso Xavier NX Sony IMX568 gstreamer capture wrong image format (image two and a half times)

  #65 opened 10 months ago by AOSMarbacher
  1